Two-position two-way direct pull diaphragm solenoid valve

　　Zero pressure start normally open / normally closed

　　2W (31) / 2W12 / 2W21 brass/stainless steel

　　The direct-pull diaphragm solenoid valve opens and closes the valve port by lifting the diaphragm by electromagnetic suction under low pressure or no pressure. Under a certain pressure, first opens the pilot hole on the diaphragm to cause the pressure difference between the upper and lower diaphragms to open and close the valve. mouth. Therefore, this type of solenoid valve is required under no pressure or low pressure conditions. If the fluid has been working at more than 0.1MPA, the YCD21 type is more economical.

　　Applicable fluid Fluid temperature

　　Air, inert gas, water, oil, and other industrial fluids Nitrile rubber (NBR): -5°C -80°C

　　(Note: When using different fluids, please select the correct sealing material to increase the service life of the product) EPDM: -20°C -120°C

　　Viton: -10°C -150°C

　　Applicable pressure connection size

　　Minimum pressure: 0 Mpa G pipe thread / NPT American thread,

　　Maximum pressure: 1.0Mpa 3/8, 1/2, 3/4, 1, 11/4, 11/2, 2

　　(When working with high working pressure for a long time (G can choose flange connection)

　　Please choose ycd11 series, which is more cost-effective

　　Selection voltage

　　DN15,20,25,32,40,50mm DC: 12V, 24V

　　AC: 220V, 110V, 24V / 50HZ;

　　120V, 240V / 60HZ

　　Applicable coil and its power (please choose plastic-encapsulated coil and H-type when damp, hot water or long-term power-on)

　　S21B/H, 22VA(AC), 15W(DC), IP65,100%ED

　　S52B/H, 35VA(AC), 20W(DC), IP65,100%ED

　　Y42B/H, 35VA(AC), 30W(DC), IP65,100%ED

　　型號

　　結構型式

　　動作方式

　　閥體材質

　　口徑范圍

　　連接尺寸

　　壓力范圍

　　流體溫度

　　2W（31）

　　直拉膜片式

　　常閉

　　黃銅

　　不銹鋼

　　12～50

　　3/8 ～ 2

　　0～1．0MPA

　　-10-80 & -10-120